Creality Creality Falcon A1 Pro control firmware (8-digit fault codes by service group)
- 01001609 — 01001609 — home return failed, limit switch not found
- 01001039 — 01001039 — value out of range
- 01001041 — 01001041 — spindle not running in CSS/sync mode
- 01001043 — 01001043 — maximum feed rate exceeded
- 01001044 — 01001044 — RPM out of range
- 01001046 — 01001046 — zero the machine to proceed
- 01001048 — 01001048 — value conflict in G-code keyword
- 01001051 — 01001051 — motor failure
- 01003304 — 01003304 — alarm service interface timeout
- 01003305 — 01003305 — did not reach target position (log command)
- 01003306 — 01003306 — camera exposure control failed
- 01003307 — 01003307 — focus light spot not detected
- 01003308 — 01003308 — abnormal camera capture
- 01003309 — 01003309 — autofocus unknown exception
- 01003310 — 01003310 — autofocus shield not closed
- 02002201 — 02002201 — module upgrade failed
- 02002201 — 02002201 — file decompression failed
- 04012008 — 04012008 — laser module has no NTC sensor
- 04011001 — 04011001 — lens dirty
- 04012002 — 04012002 — Z-axis flame alarm
- 04011003 — 04011003 — Z-axis air pressure alarm
- 04011004 — 04011004 — Z-axis die temperature too high
- 04011020 — 04011020 — Z-axis infrared module high temperature
- 04031001 — 04031001 — tilt alarm
- 06002007 — 06002007 — WiFi incorrect password
- 06002010 — 06002010 — WiFi connection timed out
- 06002012 — 06002012 — DHCP connection timed out
- 06002022 — 06002022 — SSID temporarily disabled
- 07001001 — 07001001 — flame detected (video)
- 07002002 — 07002002 — camera not detected
- 07002006 — 07002006 — autofocus failed, algorithm abnormal
- 07002007 — 07002007 — autofocus failed, no spot or out of range
- 07002008 — 07002008 — autofocus failed, bad input parameters
- 07002009 — 07002009 — autofocus failed, focus plane out of range
- 07002010 — 07002010 — autofocus failed, algorithm abnormal