01003304: alarm service interface timeout
Creality Falcon · Creality Creality Falcon A1 Pro control firmware (8-digit fault codes by service group)
What it means
Internal alarm service did not respond in time
Can I keep running?
KB severity: warning
Sources in the knowledge base may allow limited running while the fault is investigated.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
controller (firmware)
Source: Creality, fault code list
Models and controllers with this code
Source: Creality, fault code list
Related codes on this system
- 01001609 — home return failed, limit switch not found
- 01001039 — value out of range
- 01001041 — spindle not running in CSS/sync mode
- 01001043 — maximum feed rate exceeded
- 01001044 — RPM out of range
- 01001046 — zero the machine to proceed
- 01001048 — value conflict in G-code keyword
- 01001051 — motor failure
- 01003305 — did not reach target position (log command)
- 01003306 — camera exposure control failed
- 01003307 — focus light spot not detected
- 01003308 — abnormal camera capture
Related symptoms in the knowledge base
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it