M222 S7: Start processing without a project file or with the lid opened
xTool · xTool xTool S1 machine firmware/controller
What it means
Job start refused: no job file loaded or lid not detected as closed.
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
interlock (lid Hall sensor)
Source: xTool (support.xtool.com), M222 table
Source: xTool, issue description
Source: Amazon CDN (copy of xTool S1/D1 guide), 6. Troubleshooting XCS Error Codes (publisher text only)
Models and controllers with this code
Source: xTool (support.xtool.com), M222 table
Source: xTool, issue description
Source: Amazon CDN (copy of xTool S1/D1 guide), 6. Troubleshooting XCS Error Codes (publisher text only)
Related codes on this system
- M222 S4 — Device moved
- M222 S9 — Flame detected
- M222 S20 — The device reached position limits during processing
- M222 S21 — Communication exceptions between the Wi-Fi module and the main controller
- M222 S22 — Communication exceptions between the laser module and the main controller
- M363 S0 — Distance measurement exceptions.
- M363 S2 — Distance sensor signal exceptions.
- M363 S3 — The distance sensor has not been reset.
- M363 S4 — Distance measurement exceptions.
- M363 S5 — Distance measurement exceptions.
- M53 T0 — SD card exceptions or failure
- M53 T0 — The flash storage encounters an exception or is damaged
Related symptoms in the knowledge base
This alarm involves mains power, high-voltage equipment, a laser source or an interlock. This is technician-only work. Do not attempt a repair yourself. Request a technician using the form on this page.
Get a tech on it