Z-axis driver exception
xTool · xTool xTool P2 machine firmware/controller
What it means
Laser module Z axis fails to reach position at start-up.
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
motion (Z leadscrew motor / adapter board)
Source: xTool (support.xtool.com), code list
Source: xTool, issue description
Models and controllers with this code
Source: xTool (support.xtool.com), code list
Source: xTool, issue description
Related codes on this system
Related symptoms in the knowledge base
- Laser module will not move
- F1 will not fire the laser
- Fibre source powered (green blink) but no laser output
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it