ALARM:cancel: Device reported an error

xTool · LightBurn Software LightBurn

What it means

With the xTool S1 profile in LightBurn 2.2 the job stops because the S1 rejects a start-script command it does not recognise

Can I keep running?

KB severity: Machine down

The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.

The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.

Where it points in the machine

software (LightBurn device profile)

Source: LightBurn Software Forum, posts 1 to 6 (publisher text only)

Models and controllers with this code

Source: LightBurn Software Forum, posts 1 to 6 (publisher text only)

Related codes on this system

Related symptoms in the knowledge base

Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.

Get a tech on it

Tell us about the machine and the fault

We pass your details to independent technicians on the Kerfwise network. We aim to respond within 4 business hours (Monday to Friday, 8am to 5pm Brisbane time, excluding Queensland public holidays.).

Your details
The machine

Book maintenance

A response is a reply from a technician or from Kerfwise that acknowledges your job and the next step. It is not an on-site visit. We aim to respond within 4 business hours (Monday to Friday, 8am to 5pm Brisbane time, excluding Queensland public holidays.).