hard limit protection
Ruida · Ruida Ruida RDC6445G CO2 laser control system (incl. RDC6445G(S))
What it means
An axis hit a hard limit switch and the machine stopped
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
motion (limit switch)
Source: ruidacontroller.com (reseller site), 8.10 (publisher text only)
Source: ruidacontroller.com (reseller site), 8.10 (publisher text only)
Related codes on this system
Related symptoms in the knowledge base
- XCS cannot find the machine over USB
- Software stops working with the machine after a firmware upgrade (XCS or Studio below 1.6)
- mLaser will not connect to the machine
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it