T1/T2 Alarm
Raycus · Raycus Raycus RFL-C015H1 continuous fibre laser (handheld welder source)
What it means
Internal temperature sensor reads above the upper or below the lower limit
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
cooling (internal temperature sensors)
Source: CNCU (South Africa reseller), 5.2 table 8, page 25 (publisher text only)
Source: CNCU (South Africa reseller), 5.2 table 8, page 25 (publisher text only)
Related codes on this system
Related symptoms in the knowledge base
- Smoke backing into the machine; room smell, dirty sensor (all models)
- Software stops working with the machine after a firmware upgrade (XCS or Studio below 1.6)
- FTC signal wire alarm stops cutting
- Chiller panel reads normal but a red light is on and the buzzer sounds (Thunder Laser AU troubleshooting list)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it