0x98110026: Bus network alarm (instruction frame loss 0x98110026)
Gweike · Friendess TubePro
What it means
Bus command frames are being lost.
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
Where it points in the machine
bus_network (EtherCAT bus)
Source: Conintel (cypcut.ru, RU distributor), s3.2 Abnormal alarm list p59-63 (p63) (publisher text only)
Models and controllers with this code
Source: Conintel (cypcut.ru, RU distributor), s3.2 Abnormal alarm list p59-63 (p63) (publisher text only)
Related codes on this system
- Leveling failure, X, Z, B axis might reverse
- Setup error of travel range, edge seeking failure
- Incorrect height parameters
- Edge seeking failure
- Holder delay alarm
- Holder exceeds the position
- Holder alarm
- Chuck
- Excessive following error
- The follower is too close to the board
- Z axis -limit enabled
- Z axis +limit enable
Related symptoms in the knowledge base
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it