Leave-board detection timeout
Friendess · Friendess BCS100
What it means
During calibration the controller never saw the nozzle leave the sheet.
This alarm meaning was translated from non-English source material.
Can I keep running?
KB severity: setup
Sources in the knowledge base may allow limited running while the fault is investigated.
The knowledge base records this fault at technician fix level.
Where it points in the machine
calibration (capacitance calibration)
Source: CNCU (South Africa reseller), ch2 calibration alarm table p11-12 (publisher text only)
Source: CNCU (South Africa reseller), ch2 calibration alarm table p11-12 (publisher text only)
Related codes on this system
Related symptoms in the knowledge base
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
- Some areas of the same sheet do not cut through (uneven focus from bent material or table) (Thunder Laser AU troubleshooting list)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it