Jog close to board
Friendess · Friendess BCS100
What it means
Jogging brought the head too close to the sheet, so the controller blocks it to avoid a crash.
This alarm meaning was translated from non-English source material.
Can I keep running?
KB severity: warning
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
height_sensing (height control proximity check)
Source: CNCU (South Africa reseller), ch4 s4.1.14 p41 (publisher text only)
Source: CNCU (South Africa reseller), ch4 s4.1.14 p41 (publisher text only)
Related codes on this system
Related symptoms in the knowledge base
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
- Some areas of the same sheet do not cut through (uneven focus from bent material or table) (Thunder Laser AU troubleshooting list)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it