M53 S0: Access-control key removed
xTool · xTool xTool S1 machine firmware/controller
What it means
Safety access key is missing or not read.
Can I keep running?
KB severity: setup
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
interlock (access-control key)
Source: xTool (support.xtool.com), M53 table
Source: xTool, issue description
Models and controllers with this code
Source: xTool (support.xtool.com), M53 table
Source: xTool, issue description
Related codes on this system
- M222 S4 — Device moved
- M222 S7 — Start processing without a project file or with the lid opened
- M222 S9 — Flame detected
- M222 S20 — The device reached position limits during processing
- M222 S21 — Communication exceptions between the Wi-Fi module and the main controller
- M222 S22 — Communication exceptions between the laser module and the main controller
- M363 S0 — Distance measurement exceptions.
- M363 S2 — Distance sensor signal exceptions.
- M363 S3 — The distance sensor has not been reset.
- M363 S4 — Distance measurement exceptions.
- M363 S5 — Distance measurement exceptions.
- M53 T0 — SD card exceptions or failure
This alarm involves mains power, high-voltage equipment, a laser source or an interlock. This is technician-only work. Do not attempt a repair yourself. Request a technician using the form on this page.
Get a tech on it