ALM x11: Positive and negative limit alarms
WSX · WSX WSX NC6 3E auto focus cutting head (pulse or bus drive)
What it means
Limit input signals abnormal
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records this fault at technician fix level.
Where it points in the machine
limit_switch (focus motor drive (bus type))
Source: WSX (Shenzhen Worthing Technology), 11.2 bus drive
Source: WSX (Shenzhen Worthing Technology), 11.2 bus drive
Related codes on this system
- Er001 — Overcurrent protection
- Er002 — Over-voltage protection
- Er020 — Out of position tolerance
- Er00d — Line disconnection protection
- ALM x1 — Overcurrent protection
- ALM x2 — Overvoltage protection
- ALM x3 — The instruction pulse increment is too large
- ALM x4 — Locking Axis Error
- ALM x6 — Self-tuning error
- ALM x7 — The location is very poor
- ALM x8 — Encoder Disconnection Detection
- ALM x10 — Emergency stop alarm
Related symptoms in the knowledge base
- FTC signal wire alarm stops cutting
- CO2 laser tube will not fire although the laser switch is on (Thunder Nova/Mini: causes listed are beam path misalignment, loose PSU or contactor wiring, failed tube or PSU, failed opto-isolator or controller laser signal port)
- Chiller panel reads normal but a red light is on and the buzzer sounds (Thunder Laser AU troubleshooting list)
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it