Material collision (touch part) alarm when follow is enabled
Weihong · Weihong Weihong NcStudio V15 laser tube cutting control system (LT3200)
What it means
Measured capacitance fell to or below the touch-part value during idle follow or cutting
Can I keep running?
KB severity: Machine down
The knowledge base lists this as a machine-down fault. Stop the job and do not keep running until a technician has checked the machine.
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
height_sensing (capacitive sensing)
Source: Weihong (official OSS file store), 4.5 troubleshooting
Source: Weihong (official OSS file store), 4.5 troubleshooting
Related codes on this system
Related symptoms in the knowledge base
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it