ERROR:02: no G-code file in TF card root
Creality Falcon · Creality Creality Falcon2 / Falcon2 Pro control board firmware
What it means
No runnable job file found on the card
Can I keep running?
KB severity: setup
The knowledge base records some owner-level checks for this fault. That is not a repair procedure from Kerfwise.
Where it points in the machine
job_setup (TF card)
Source: Creality, ERROR:02
Models and controllers with this code
Source: Creality, ERROR:02
Related codes on this system
- ERROR:01 — angle data abnormal
- ERROR:04 — no airflow detected
- ERROR:05 — flame detected
- ERROR:06 — lens contamination detected
- ERROR:07 — laser module temperature high
- ERROR:08 — module air pressure sensor fault
- ERROR:09 — module flame sensor fault
- ERROR:10 — module lens sensor fault
- ERROR:11 — no LD temperature sensor
- ERROR:12 — LD sensor short circuit
- ERROR:13 — module CPU temperature too high
- ERROR:14 — host CPU temperature too high
Do not attempt DIY repair on high-voltage or Class 4 laser equipment. Get a technician. You can request one using the form on this page.
Get a tech on it